Wire
WHS-1 Wire Harness Spoon
$39.35The WHS-1 wire harness spoon is used to assist in inserting new wires into existing wire harnesses. It helps thread new or repaired wires under tight cable ties, zip ties,...
UL Duplex Boat Cable | 18 AWG, Red/Black, White Jacket | 500ft
$160.98Duplex Boat Cable is used in low-voltage AC applications as well as DC circuits. Pacer manufactures 18 AWG Duplex boat cable in-house in Sarasota FL, USA for the best quality....
TSK8000 Die Assembly | 0.141 to 0.150in Wire Diameter, 1-Conductor, Left Lay
$417.19These die sets are used with the TSK8000 Twist-strip(c) to strip the outer jacket on multi-conductor cables. This die assembly (EDMO# TSD1150) is designed to strip left-laying cables with one inner...
Heat Shrink Ring Terminal | 16-14 AWG, #8, 100pc
$55.32Ring terminals are used to create electrical connections. By using ring terminals, you won't have to worry about the connector pulling off. The ring fits securely over a screw or...
Rotary Safe-T-Cable Application Tool | 3in Nose, 0.032
$807.28The SCTR tool series features a rotary tension mechanism which can be adjusted to precise cable tension requirements. This necessary control feature is very popular with users. The tension will...
REPLACEMENT NOSE/For Safe-T-Cable Tool, .032/5 inch
$293.31REPLACEMENT NOSE/For Safe-T-Cable Tool, .032/5 inch
Safe-T-Cable Nose Assembly | 3-inch, For 0.032-inch Safe-T-Cable Assemblies
$400.49Safe-T-Cable nose assemblies rotate 360° and are available in 1”, 3”, 5”, 7”, and 9” lengths. Low-profile noses are available for applications where the clearance between the fastener head and...
Safe-T-Cable Torque Verification Block | 0.022", 0.032", 0.040", Right Hand
$298.90Torque verification blocks allow for the verification of Safety-T-Cable tools. Tensioning mechanisms are verified using the Safe-T-Cable torque verification block and a push force tester.Torque verification block (EDMO# SCT-TB1R) configured...
SCT-TB1 Torque Verification Block | For 0.022", 0.032", and 0.040" Safe-T-Cable
$300.28Periodic verification of tool indenter and tensioning mechanism settings is done with the Safe-T-Cable(c) Torque Verification Block. Indenter setting should be verified periodically and must always be checked if the nose...
MG-1300 Cable Tie Cutter
$71.50The MG-1300 cable tie removal tool removes cable ties and lacing cord without damaging the bundled wire. Safety guards slide behind the strap or lacing cord and prevent the blades...