The DMC1898 wiring service kit contains the cross-reference information for which tools, contacts and terminals to use when servicing wiring systems. This kit guides technicians towards the correct tool selection...
The WHS-1 wire harness spoon is used to assist in inserting new wires into existing wire harnesses. It helps thread new or repaired wires under tight cable ties, zip ties,...
These die sets are used with the TSK8000 Twist-strip(c) to strip the outer jacket on multi-conductor cables. This die assembly (EDMO# TSD1150) is designed to strip left-laying cables with one inner...
The SCTR tool series features a rotary tension mechanism which can be adjusted to precise cable tension requirements. This necessary control feature is very popular with users. The tension will...
REPLACEMENT NOSE/For Safe-T-Cable Tool, .032/5 inch
Safe-T-Cable nose assemblies rotate 360° and are available in 1”, 3”, 5”, 7”, and 9” lengths. Low-profile noses are available for applications where the clearance between the fastener head and...
Torque verification blocks allow for the verification of Safety-T-Cable tools. Tensioning mechanisms are verified using the Safe-T-Cable torque verification block and a push force tester.Torque verification block (EDMO# SCT-TB1R) configured...
Periodic verification of tool indenter and tensioning mechanism settings is done with the Safe-T-Cable(c) Torque Verification Block. Indenter setting should be verified periodically and must always be checked if the nose...
The DMC1535 Light Armored Vehicle LAV-25 & LAV-AT Wiring System Maintenance Kit provides a turn-key solution and the tools necessary to strip, crimp, install and remove the typical contacts and...